STM32U3 Naquada M.2 Memory Connector Application

Naquada application demonstrating the deployment of M.2 memory connector application.

---

Features Demonstrated in This Example

• M.2 memory connector with naquada board on STM32U3

---

Build application

Build application for development

• open Project.eww in Naquada/EWARM with IAR EWARM v9.60.3
• click on build icon

---

Execute application

When application is built for development

• plug a memory board in the M.2 connector
• connect USBC cable to the naquada carrier board
• connect STLINK V3 mini to the carrier board
• connect USBC cable to the STLINK mini
• use and configure tera term (115200, 8 bit, no parity 1 stop bit, no flow control)
• use the load button to flash the STM32U3 with the application.
• reset or use the go button to launch the application

You should see the following output on the console

M.2 MEMORY BOARD TEST INFO  : start of the test, do not unplug

M.2 MEMORY BOARD TEST INFO  : EEPROM IDs detected

M.2 MEMORY BOARD TEST INFO  : EEPROM CPN : MB1928-18LA-C01

M.2 MEMORY BOARD TEST INFO  : Flash memory test is PASSED

M.2 MEMORY BOARD TEST INFO  : Safe to unplug the M.2 memory board

---

Feedback and contributions

Please refer to the CONTRIBUTING.md guide.